The standby submersible slurry pump shall roll the shaft / turn every week to make the bearing uniformly accept the static load and external oscillation. The building structure in the water pump room shall be reconstructed. Sound absorbing and isolating plates shall be installed around the wall and on the top of the machine room and fixed with light steel keel; The connecting holes between the machine room and other rooms are tightly blocked,　　It is occasionally found that there is insufficient liquid supply when using,WuhanCentrifugal slurry pump, so what are the reasons for this situation and how to deal with it.Wuhan,　　 the experimental water shall meet the relevant process requirements.　　 Then reinstall the equipment on the engine and install the rubber hose.Myanmar,　　 Another possibility is that the gas is sucked in when the pump is in use.　　Basically the reasons for the motor heating of the submersible slurry pump are the above items. If the motor heating occurs, you can find the reasons from the above items. However, it must be noted that if the fault is caused by electricity people who do not know electricity should not repair it by themselves, so as to avoid people　　The water pump is not only the water supply for the city, but also the household water purifier used in our home. There is a with pump equipment to help us purify water. In any way, it can be divided into many types, each of which has different sizes, volumes and s. Therefore, many people believe that

　　So it is called: submersible slurry pump.　　 Check the suction pipe and bottom valve to see if there is any air leakage source. Remove the silt and other obstructions at the water inlet. Check the water inlet depth of the bottom valve to ensure that it is not less than times the diameter of the water inlet pipe. If it is not enough, deepen the water inlet depth of the bottom valve.　　Some of them are OK. For irrigation and other purposes, in fact, we choose to use larger flow. Let&#;s take a look at the method of selecting pumps.Market trend,　　The operating environment is different: the key difference between the submersible slurry pump and the vertical slurry pump lies in diving. During the operation of the vertical slurry pump, some parts intrude into the pit and cannot completely invade the slurry; The submersible slurry pump can completely penetrate below the slurry level.　　If there is a standby pump, it is recommended that the two pumps be used in turn. When the equipment is in use, it can pretend that a filter screen plays the role of filtration, you can start working.

　　The use of water pumps is related to all aspects of our life. With the arrival of the May Day holiday,WuhanHorizontal wear-resistant slurry pump, the water consumption will increase. Therefore, it is necessary for us to choose a suitable water pump.Safety and health,　　Avoid airborne sound transmission; Ensure the airtightness of machine room doors and windows. The water pump is equipped with a sound proof cover, and an exhaust fan is added inside the cover to ensure the ventilation of the equipment. At the same time, the inlet and outlet of the sound proof cover are equipped with silencing equipment. A vibration isolation platform is installed at the bottom of the water pump for foundation vibration reduction to isolate the vibration generated during the operation of the water pump　　 sedimentation tanks, hydropower stations, reservoirs, rivers, open caissons mines and fish ponds.　　The effective power is also called output power, which is expressed by PE. It is the effective energy obtained in the pump by the medium liquid output from the pump in unit time.Wuhan,　　Then there are new structures, backup seals and asymmetric molded metal single wall bellows seals.　　Normal operation. The submersible slurry pump can transport the slurry with corrosive or solid particles, coal slurry heavy medium transportation and dredging the river. When the equipment is pumping sand, some sand layers around the equipment will make the equipment covered by a large amount of sediment, and the current will slowly increase during use. Well, we should choose　　 bind the exposed copper wire to the cable core evenly, heat it with an electric iron, and infiltrate tin evenly.