When the landing door is closed,OstholtPabiannis, the full width of the lifting passage opening should be covered.Setting requirements: For construction electric elevators that operate in multiple shifts, the handover system should be implemented,The stopper bearing of the mechanism is kept intact.When the distance between the outer edge of the construction electric elevator and the edge line of the external overhead power line cannot meet the requirements in the table above, effective protective measures should be taken.Kingston,The foundation production and acceptance of electric elevators for foundation construction should comply with the user manual and regulatory requirements.News Abstract: The development of the lifting platform industry will continue to grow in recent years! With the continuous development of electric lifting machinery for high-altitude operations in recent years, the products of electric lifting platform vehicles have been continuously improved, and various new technologies and materials have emerged, making the further development of lifting platform vehicles possible.Setting requirements: Each landing entrance should be equipped with a landing door, which should cover the opening with its full width, and should not open towards the lifting passage.

Operating cost advantage and low failure rate: Due to the use of advanced hydraulic systems and good methods,OstholtRotterdam, the operating failure rate can be reduced to a low level.The installation position of the lower limit switch. The installation position of the lower limit switch should ensure that the contact plate triggers the switch when the rated load of the suspension cage decreases, the contact plate should also be close to the triggering of the lower limit switchSpiral electric lifting mechanism: With all the functions of a regular lifting platform,Especially suitable for steel structured factories suitable for both indoor and outdoor installation.Setting requirements: The anti loosening and anti loosening parts between the connecting parts should comply with the provisions of the user manual and should not be replaced by other objects. For connecting bolts with pre tightening requirements, a torque wrench or special tool should be used to accurately tighten the bolts to the specified torque value according to the specified tightening sequence. When installing standard section connecting bolts, it is advisable to place the screw at the bottom and the nut at the top.Many theaters use a lifting platform as a vertical transportation tool for goods. The rear of the main stage or the end of the side stage in many theaters are equipped with a set container transportation lifting platform, which is used to vertically transport items from the ground to a designated location or even the stage plane. The lifting platform of the music pool is often used for transporting movable seats, etc.

Setting requirements: The spacing of wall brackets along the vertical direction should comply with the provisions of the user manual.Click to view,High lifting height, using side mounted oil cylinders, stable operation, noise free easy maintenance, and longer service life.The working principle of the aluminum alloy lifting platform is that hydraulic oil is composed of a vane pump to form a certain pressure, which enters the lower end of the hydraulic cylinder through an oil filter, explosion-proof electromagnetic directional valve, throttle valve, hydraulic control one-way valve, and balance valveSecondly, the lifting platform is driven by electrical energy and lifted by the hydraulic system. During operation, it is necessary to avoid irregular operations. To ensure the normal and orderly operation of the lifting platform and achieve the ideal unloading level, timely inspection of various functions is essential.Ostholt,Low power consumption: When the hydraulic guide rail lifting platform descends,OstholtBelle Asha Lun, it is driven by the pressure generated by its own weight, greatly saving energy and reducing consumption.The quality of the standard section should comply with the product manual and specification requirements.When a rigid mm square or circular flat surface is applied with a normal force of N to either side of the door, the door may not meet the above requirements, but safety should be maintained.