Safety performance: Electric elevators not only have the safety device of traditional traction elevators, but also have an overflow valve to prevent excessive system pressure during upward movementEspecially suitable for steel structured factories, suitable for both indoor and outdoor installation.Manhattan,When a single steel wire rope is excessively stretched, the Electrical safety device shall stop the operation of the electric lift.Setting requirements: The landing door should be standardized and tooled.Jipijapa,Emergency manual valve: In case of power failure, it can cause the car to descend to the nearest floor position and open the doorPipeline rupture valve: When the hydraulic system pipeline ruptures and the car stalls and descends, it can automatically cut off the oil circuit and stop descentSetting requirements: The quality of the standard section should meet the requirements of the product manual. Before installing the construction electric elevator,ManhattanPescara,ManhattanLi Shi, all components should be inspected, and standard sections and other components with severe wear and deformation should be replaced.

It is understood that the scissor type lifting platform is a widely used specialized equipment for high-altitude operations. Its shear fork mechanical structure provides high stability for the lifting platform, wide working platform and high load-bearing capacity, making the range of high-altitude operations larger and suitable for multiple people working simultaneously. The lifting power is divided into V, V or V power supplies diesel engines, using Italian and domestic hydraulic pump stations, and the table top is equipped with anti slip insulation buckle plates, which have anti slip, insulation, and safety features. Please rest assured to use.After the limit switch is activated,Speed limit wire rope switch. When the speed limit wire rope trips or breaks. Make the electric elevator unable to start.Chain type electric lifting mechanism: With a good guiding mechanism, it can ensure that the equipment does not tilt during operation. Gear and rack electric lifting mechanism: precise transmission and high cost.The safety notice board for construction electric elevators should be prominently placed on the hanging cage for the rated load capacity and rated number of passengers of the construction electric elevator. It is strictly prohibited to use construction electric elevators beyond the rated load capacity or rated number of passengers.

The bearing capacity of the ground under the concrete foundation plate should be greater than .Mpa.analysis,Protective measures should comply with regulatory requirements.Construction electric elevators should be equipped with travel limit switches, as follows: automatic reset type upper and lower limit switches should be installed on construction electric elevators, but the upper and lower limit switches should not be triggered as highThe net height of the landing door opening should not be less than m, and the difference between the net width and the outlet width of the cage door should not exceed mm. When the floor door is closed,ManhattanWeiwozrawek, except for the gap between the lower part of the door that should not exceed mm, the size of any through-hole and opening related to the distance between any door and adjacent moving parts, should comply with the provisions of Table of 'Mechanical Safety - Safety Distance to Prevent Upper and Lower Limbs from Touching Dangerous Areas' GB-.Manhattan,Electric elevators used in various places.Implementing multiple shifts of homework should fill in and submit records according to regulations.Electric elevators used in various places.