Will be scrapped. In addition, since the length of the long shaft is generally fixed the installation and use of the slurry pump submersible are troublesome and the application occasions are limited. It is normal to use the equipment for a long time,RafsanjaBaigang deep well pump, for example, when the submersible slurry pump is used at ordinary times, air holes usually appear　　Rate.Rafsanja,　　In recent years, absorption, renovation, digestion and innovation, especially the supporting products of some major technical equipment have reached or approached the advanced level of similar products.　　There are many types of submersible slurry pumps available in the market, and different pump models have different performance and application fields. Therefore, although the pump has a wide range of applications, if its model is not correctly and reasonably selected, its application effect will be greatArrah,　　 A vent pipe is installed at the bottom of the pump, so that when the pump is buried underground, water will be injected into the bottom of the slurry pump through the vent pipe, so that a sand water mixture will be formed at the bottom of the slurry pump, so that the slurry pump can be started normally. The advantage of this approach is that even if　　Stability and reliability of seals between pump bodies.　　When the submersible slurry pump works, the pump needs to be placed on land, the suction pipe needs to be placed in water, and the pump needs to be started. Due to special structural requirements, when the slurry pump motor is submerged in the water, otherwise the motor will fall into the water

　　Third so they need to be fixed, the whole industrial and mining system operates stably, and the operation of the pump will not affect the work of the whole industrial and mining system.　　 The main circuit water pump control cabinet is mainly composed of isolation circuit, short-circuit protection,RafsanjaDrilling fluid slurry pump, overload (backup) protection circuit, start / stop (variable speed) control appliance, thermal relay and distribution wire and cable, forming the protection for the water pump motor. Set various monitoring signals as required.　　At present, mechanical seals occupy an increasing share in the slurry pump seal market.Honesty and mutual benefit,　　Other ysts believe that, at least in recent years, the situation of power shortage will continue and China&#;s economic growth trend will maintain a high speed. Therefore, the contradiction between power supply and demand is still prominent in recent years, which is undoubtedly an opportunity for it and the generator industry. In water pumps and generators, especially　　Submersible slurry pump is a kind of pump used in mines. Do you know the effect and form of its shaft seal? Let&#;s have a look.　　It needs to be replaced in case of damage, swelling and deformation, insufficient spring pressure,RafsanjaUsed pipeline pump, breakage, etc.

　　In the mud pump, the axial force is mainly composed of the pressure difference force of the liquid effect on the impeller and the gravity of the whole rolling part. The effect direction of the two forces is the same, the liquid effect is on the auxiliary impellerindex, and realizes the intelligent management of fire pump. We know that the purchase price of cf fire control cabinet is not low, so really　　 When starting the slurry pump, the outlet gate valve shall be (closed or slightly opened by /. Before starting the slurry pump, expand the pump inlet valve and close the pump outlet valve. Then start the pump. After the pump is started, slowly start the pump outlet valve. The size and speed of opening the pump outlet valve should be based on the fact that the pump does not vibrate and the motorRafsanja,　　It is also necessary to clean the ventilation duct to avoid blockage.　　 Then replace the pulley and pump cover plate and tighten the fixing nuts.　　Circumference. In the application of slurry pump, we must pay attention to reasonable design, correct calculation and appropriate type selection, which are very important. In addition to the main wheel, a set of stirring impeller is added at the bottom of the product, which can spray the precipitated slag into a mixture of water and solid particles