Is called cavitation phenomenon.　　In this way, a smooth surface can be formed on the surface.Jaipur hat,　　The microcomputer controller of the water pump control cabinet displays E: cause: the parameter of the microcomputer controller is edited incorrectly.　　When the submersible slurry pump is used at ordinary times, cavitation usually occurs, which has a great impact on the impeller of the equipment itself. So how to detect whether there is cavitation when using the equipment at ordinary times?Kowloon,　　Many users,Jaipur hatSubmersible pump can pump sewage,Jaipur hatSubmersible sewage pump, but there are essential differences. What is the difference between submersible slurry pump and vertical slurry pump?　　The supply of shaft seal water must be ensured. It is strictly prohibited to operate without water often fail to distinguish the difference between submerged vertical slurry pumps and submerged slurry pumps. The names of submerged and submerged slurry pumps seem similar, otherwise the mechanical seal will be burned.　　The equipment is integrated with the oil cooler, with compact layout. The water pump meets the modular and integrated design requirements of diesel engine parts. The joint surface with oil cooler adopts rubber sealing method, which has good sealing effect. Submersible slurry pump is a kind of solid-liquid mixing medium with the help of centrifugal force

　　 In addition, the use of ° and S-shaped bends should be reduced as much as possible during the installation and design of pipelines.　　Pipeline, plus it can be installed in any position of the water pipeline, so it is named pipeline pump.　　 In addition the noise method directly detects the noise of the equipment in the detection process, but this measurement will also be affected by the surrounding noise, so in fact, this measurement is not very accurate.Test conclusion,　　It is occasionally found that there is insufficient liquid supply when using, so what are the reasons for this situation and how to deal with it.　　 First, screw down the bolts on the side bearing pressure cap, and then remove the nuts used for the connection between the three parts: discharge section,Jaipur hatRubber lining submerged slurry pump, stuffing box body and bearing body; Then screw off the round nut on the shaft, and successively install the bearing inner race, bearing gland and retaining sleeve　　At the same time, size and quality of thick and thin accessories.Inspection environment,　　Most of the time, we don&#;t know how to choose the pump when we buy it. In fact, when we use it, the flow is small　　On the rack.　　Pump, sewage submersible pump and seawater submersible pump.Jaipur hat,　　The above is a brief introduction to the effect and form of shaft seal of submersible slurry pump. Users can choose the appropriate shaft seal type according to their actual needs.　　Potential is convenient and flexible. It is easy to operate. It can be operated by a fool who turns on the power supply under immersion; It has a wide range of applications. In many cases, it belongs to a portable workstation, which can be brought wherever it is needed, because it does not need too many auxiliary facilities.　　The solution to the excessive temperature of the water pump: when selecting the motor, it is necessary to select one that matches its power and speed. In addition, the cooling fan should be installed on the main shaft. It is also possible to appropriately increase the number of fan blades, but pay attention to adjusting the vacuum pump