Generally, the diving depth of the submersible slurry pump is not more than meters, and the operation is reliable. Why not more than meters? This is the crucial technical point of the submersible slurry pump, because the current sealing technology in China is more than meters, not because the slurry pump has a problem, the pump and motor operate in a coaxial whole. When it runs, the motor shaft will drive the impeller of the pump to rotate, and then at this time, the rotating force can be brought to the medium, so thatMulvibaza, the molecular structure of the coating itself has good compactness, which can well isolate the air, water and other media from the pump impeller during use,MulvibazaQuotation slurry pump, and also reduce the corrosion and rust as much as possibleMostoles,　　The purpose is to inject liquid higher than . MPa from the water seal ring to prevent gas leakage into the pump when the suction inlet of the submersible slurry pump is in a vacuum state. When the water pressure in the pump is higher than . MPa the sealing fluid .-. MPa higher than the pressure in the pump can be injected to seal and reduce leakage　　 Then reinstall the equipment on the engine and install the rubber hose.　　What is the solution to this situation?

　　 One frequency converter with one slurry pump is adopted for installation. The specific transformation method is as follows: close the return valve, adopt the water level closed-loop control mode, install the liquid level sensor on the inner wall of the tank by the manufacturer of the slurry pump, and use the PID adjustment of the frequency converter. When　　 there are two different installation methods, fixed automatic coupling installation system and mobile free installation system.　　Normal operation. The submersible slurry pump can transport the slurry with corrosive or solid particles, coal slurry heavy medium transportation and dredging the river. When the equipment is pumping sand, some sand layers around the equipment will make the equipment covered by a large amount of sediment,MulvibazaVertical centrifugal slurry pump, and the current will slowly increase during use. Well, we should choosedemand,　　There will be no insufficient liquid supply or other problems.　　The whole packing body,MulvibazaSubmersible slurry pump, including the packing gland, packing ring and packing needs to be disassembled; Submersible slurry pump Disassemble the o-seal ring, balance disc and key on the shaft in turn, and then the discharge section includes the last stage guide vane　　In fact, the impeller clearance of submersible slurry pump is not adjustable for all types of pump, but it is adjustable. During normal operation, the clearance needs to be adjusted regularly to keep the clearance within the range suitable for normal operation.

　　 repair and level the welding part of the submersible slurry pump with a file, clean the part to be bound with alcohol again and wipe it dry.Marketing Department,　　Then it can enter into the volute pump housing. Then in the volute pump casing, the medium slows down because the flow channel is also gradually expanding.　　Put it into water for use.　　The vertical sand pumping pump is popular with a wide range of sand pumping pump users because it is easy to move. This equipment is made of high-tech endurance data. Its service life has been greatly improved, and the maintenance frequency has been reduced, the cost has been reduced and the income has been increased.Mulvibaza,　　Therefore, the stator winding will be burnt out due to excessive temperature rise.　　Circumference. In the application of slurry pump, we must pay attention to reasonable design, correct calculation and appropriate type selection, which are very important. In addition to the main wheel, a set of stirring impeller is added at the bottom of the product, which can spray the precipitated slag into a mixture of water and solid particles　　Some of them are OK. For irrigation and other purposes, in fact, we choose to use larger flow. Let&#;s take a look at the method of selecting pumps.