Setting requirements: The spacing of wall brackets along the vertical direction should comply with the provisions of the user manual.Secondly, for the replacement of hydraulic oil on the lifting platform, it can be replaced once a year. The hydraulic oil must be clean, and after changing the hydraulic oil, it must be automatically lifted and lowered to times to ensure that the air in the oil cylinder is completely discharged, maintain sufficient space,ColumbusKoenipus, and ensure that the lifting platform can be lifted to the rated lifting height.Columbus,Unloading platform and attached electric construction platform, etc.Tank oil temperature protection: When the oil temperature in the tank exceeds the standard setting value, the oil temperature protection device sends a signal to suspend the use of the elevator. The elevator can only be started when the oil temperature dropsSungai PetaniSetting requirements: The landing door should be standardized and tooled.Setting requirements: For construction electric elevators with foundations installed on roof slabs, floors, or other lower suspended structures, the bearing capacity of the foundation support structure should be checked. Click here to download the construction technical information for free. Basic drainage facilities should be installed.Operating cost advantage and low failure rate: Due to the use of advanced hydraulic systems and good methods, and its attachment distance, wall bracket spacing,ColumbusAsperni, and end height must comply with the requirements of the 'User Manual'. The angle between the plane of the wall bracket and the normal direction of the attachment surface should not exceed degrees;. When the attachment device does not meet the requirements of the 'User Manual' due to conditions, its calculation sheet, design,ColumbusHouma, and production materials should be confirmed by the manufacturer or reviewed by the technical leader of the installation unit, and verified by experts.Affordable price,Every theater is a public place with a large number of people, and safety considerations should be taken into account in stage design. According to relevant national regulations, in order to prevent accidents caused by the crushing of electric elevators or improper control by drivers. Electric elevators should be equipped with the following necessary safety devices to ensure that the car of the electric elevator stops rising or falling in a timely manner.There is no need to set up a computer room above the shaft like an elevator, and the top floor height can be installed at least . meters.Work is essential, and the main protective accessories include safety belts, guardrails, protective covers, platforms and stairs, etc.

Secondly, for the replacement of hydraulic oil on the lifting platform, it is recommended to replace it every three months. If the frequency of use is not high, it can be replaced once a year. The hydraulic oil must be clean, and after changing the hydraulic oil, it must be automatically lifted and lowered to times to ensure that the air in the oil cylinder is completely discharged, maintain sufficient space, and ensure that the lifting platform can be lifted to the rated lifting height.Trustworthy,It is reported that a fixed electric elevator has good lifting stability and can only be used for fixed operations, making high-altitude operations easierCheck the starter potential when the lifting table is not raised or the voltage is too low when the motor load is working. Voltage hydraulic range allowed&When the foundation is set on the roof or floor structure, the bearing capacity of its supporting structure should be checked.ColumbusAfter the electric elevator passes the inspection, the user unit shall organize the leasing unit, installation unit and supervision unit to conduct acceptance. For the implementation of construction general contracting, the acceptance shall be organized by the construction general contracting unit. The acceptance form should be signed by the relevant responsible person.Acceptance: Concrete strength grade C, strength testing report.The advantages and disadvantages of several commonly used electric lifting mechanisms are as follows: hydraulic electric lifting mechanisms: using hydraulic technology