Then tighten the compression nut on the packing gland evenly to make the liquid leak out in drops, and pay attention to the temperature rise outside the packing chamber.　　 When adding lubricating oil to the pump at ordinary times,NarayangangeZD slurry pump, the metering must be controlled, and the excess lubricating oil in the pump must be discharged and replaced regularly.Narayangange,　　I would like to talk with you about the problems that should be paid attention to when using deep well pumps.　　With water you can start working.Talagante,　　Whether the pump is evacuated or overflowed, etc., and handle it at any time.　　 The submersible slurry pump usually relies on water cooling to dissipate heat. If the motor leaks out of the water without water cooling, the motor temperature will rise, so it is easy to burn out the motor.　　Some impurities will entangle the impeller, so generally, the open impeller will be used, so there is no need to worry about getting stuck in the process of transporting sewage.

　　 In addition, the use of ° and S-shaped bends should be reduced as much as possible during the installation and design of pipelines.　　For the pipeline pump in the workshop, it is necessary to consider whether the pipeline pump is worn to a certain extent due to inadequate maintenance, but the performance of the pipeline pump is degraded. In case of abnormal water absorption during installation,NarayangangeHorizontal wear-resistant slurry pump, check the motor during installation and check the motor wiring and speed,　　 Dust and oil stains on the motor reduce the heat dissipation capacity of the equipment and cause the equipment temperature to rise.device management,　　In fact, the pumps I am going to talk about here have a wide range of uses. Pumps are required for both civil and military purposes, as well as for advanced technologies, especially in the mining, chemical, metallurgical and other industrial sectors. It is a widely used general mechanical equipment. Most pumps are corroded or severely corroded　　 Structural features and working principle qsz submersible slurry pump is a coaxial integration of water pump and motor. During operation, the motor shaft drives the water pump impeller to rotate, and transmits energy to the slurry medium to generate a certain flow rate, drive the solid flow, and realize the transportation of slurry.　　Turn on the power supply type fool operation; It has a wide range of applications. In many cases, which can be brought wherever it is needed, because it does not need too many auxiliary facilities.

　　Its main features are as follows: the whole machine is a dry-type motor pump structure. The motor is protected by mechanical seal, which can effectively prevent high-pressure water and impurities from entering the motor cavity. In addition to the main impeller, it is also equipped with a mixing impeller, which can pump out the slag settled at the bottom after stirring into turbulence. impellersystem, and pressurized water supply in high-rise buildings. And in the　　Carbon building materials, chemical industry and other industrial industries are mainly used to transport abrasive pastes containing solid particles.Narayangange,　　Its main features are as follows: the whole machine is a dry-type motor pump structure. The motor is protected by mechanical seal, which can effectively prevent high-pressure water and impurities from entering the motor cavity. In addition to the main impeller, it is also equipped with a mixing impeller, which can pump out the slag settled at the bottom after stirring into turbulence. impeller　　After meters, a new gasket shall be replaced. The removed parts shall be cleaned with kerosene before assembly.