it will also lead to the burning of the motor.　　How to avoid this situation when the equipment is in use.Balahani　　 Use a V insulation resistance meter to measure the insulation resistance between phases and phase to ground of the electric pump motor, and the value shall not be less than m Ω. Otherwise, the motor stator winding shall be dried, and the drying temperature shall not exceed ℃.　　Stability and reliability of seals between pump bodies.Carrara,　　 The fixing method of the impeller is changed from screw thread to key clamp to prevent the impeller from falling off and causing damage!　　The other mechanical seal is a split seal, so that the equipment can drive the solid to flow when it is in use, so that the slurry can be transported. In terms of the principle of the submersible slurry pump, it is actually quite simple　　 Check the voltage to see if the voltage is too low to drive. Or the power does not match the speed or the belt slips, resulting in low speed.　　The Tao part also consumes part of it.Inspection standard,　　In the application of pumps, the first thing we think of is water. Whether it is drinking water or coefficient water, even the polluted water in cities needs to be purified. All these require its equipment to provide services for us. Without pumps, our basic survival is a problem.　　Superior, complete protection s, reasonable structure, convenient installation and high cost performance. In case of sudden power failure of the plant and emergency, the water pump will automatically start to supplement the pipe network pressure.　　The whole packing body, including the packing gland, packing ring and packing, needs to be disassembled; Submersible slurry pump Disassemble the o-seal ring, shaft sleeve, balance disc and key on the shaft in turn,BalahaniSmall deep well pump, and then the discharge section includes the last stage guide vane

　　When the submersible slurry pump is used at ordinary times cavitation usually occurs, which has a great impact on the impeller of the equipment itself. So how to detect whether there is cavitation when using the equipment at ordinary times?demand,　　The first stage impeller of the pump is disassembled; It is also necessary to screw down the connecting nut between the water absorption section and the bearing body and the bolt on the bearing pressure connection, so that it is convenient for us to disassemble the bearing parts; When the shaft is pulled out from the suction section, the fixing nut on the shaft shall be　　Pipeline pump is also called pipeline centrifugal pump. According to the structure, pipeline pump can be divided into vertical pipeline pump and horizontal pipeline pump. Can the pipeline pump suck water? Recently, a customer asked this question. Most pipeline pumps have self-priming . It&#;s just that different types of pipeline pumps　　Screw it down, and then remove the bearing inner race,BalahaniSplit vertical pipeline pump, O-ring, shaft sleeve and retaining sleeve in turn.Balahani,BalahaniDeep well submersible pump,　　It is not correct that it has no effect on us.　　 The gas inadvertently entered in the equipment is discharged and good sealing performance is ensured.　　Now you know the reason why the pump has air turbidity. In fact, this is a very common phenomenon. You don&#;t have to worry about it. Water pump can transport many things, such as water, oil, liquid metal