and the transaction was fair. With the increase of coke price

The price of pig iron market rose by - yuan this week, the cost of ductile iron in Shanxi, Henan, Liaoning, Shandong and other regions has increased. In addition, with the gradual release of downstream demand, the inventory of iron plants is not large, and iron plants have successively raised their prices. There are few iron foundries in Shandong, Jiangsu, Hebei and Shanxi, and the inventory remains low. As the coke price rises and the cost increases, the price of iron foundries rises again.Although the opening continued the weak trend, the intraday transactions improved, and the prices of some copper bar manufacturers rose. From the specific situation, although the manufacturer feedback that the shipment is average, the market inventory is not much and the manufacturer is not willing to significantly reduce the price. In terms of the market, the transaction of strip steel is better than other steel varieties, and the downstream mainly focuses on callback buying without panic inventory clearing. It can be seen that although the steel market continues to shake, the overall demand for strip steel remains in a good state.Ban La sadaFinland,When the copper tube is heated and the flux melts into liquid, place the preheated electrode on the welding point immediately. As soon as the electrode begins to melt, move the flame nozzle back and forth until the solder flows into the gap between the two tubese the flame, let the solder contact the welding point, and then remove it after a few seconds. If it is suspected or found that there is still a gap between the two pipes. It can be heated again to make the flame nozzle move continuously at two points. A small amount of solder can be added.To sum up, due to the influence of factors such as the current spot market price is much higher than the expected winter storage price of merchants, and the weakness of raw material support, the author believes that in the short term, the spot building materials do not have the possibility to rise significantly, and the price of building materials may mainly operate in shock, but with the shrinking demand, the supply and demand pressure becomes prominent, However, it is still possible for merchants to lower the spot price in November.Mocheng,The market price of Zhengzhou copper bars is basically stable, and the shipment is not good. In terms of tube blank: today, Shandong Luli tube blank slightly reduced by yuan, and the current mainstream ex factory price is - yuan. In terms of pipe plant: Linyi Pipe Plant locked the price for a week. With a stable market mentality, the factory price of hot rolled seamless pipes is now between - yuan. On the market side: with the arrival of the off-season, traders generally ship goods at a high price. Replenishment is mainly to maintain the existing inventory, and there is no large replenishment plan. The demand is sluggish, and the market price of Zhengzhou copper bar is expected to be stable and declining.Copper tube is also called copper tube nonferrous metal tube. It is a pressed and drawn seamless pipe, characterized by light weight good thermal conductivity, high low-temperature strength and corrosion resistance. Because of these excellent properties of copper tubes, the use of copper tubes is very common. What are the differences between hard copper tubes and soft copper tubes in the use process? What are the differences between the two in terms of specific applications?The hard copper tube is not artificially treated after being drawn or extruded, so that it can be naturally formed. At this time, the organizational form in the copper tube is full. This kind of copper tube is more likely to crack and is not suitable for bending. Therefore, the hard copper tube is generally straight.

The blowing mouth of the welding tool should not be too small to avoid excessive concentration of heat.The verdigris on the surface of brass tubes are formed by reacting with sulfides in the atmosphere.According to * * new data, in September , China s imported iron ore * * * broke through the million ton mark, reaching million tons, a record high; From January to September, China s iron ore import increased by % to million tons, and the annual import volume is expected to exceed billion tons. However, judging from the shipment of imported ores after the National Day, due to the rapid declinecline in iron ore prices the iron ore price index once fell below $, which reduced the enthusiasm for the shipment of imported ores. In addition, environmental protection inspection has become stricter, and the supply of some domestic mines has been greatly affected. The current operating rate of domestic mines is percentage points lower than the previous peak, which is likely to decline further in the future.Trustworthy,In consideration of the above factors,Ban La sadaFinland310s stainless steel coil, more and more steel plants have stopped production since October, and the production limit in Wu an and Tangshan heating seasons has been advanced. In addition,Ban La sadaFinland304 stainless steel round steel, the formal implementation of production limit in & quot; +& quot; urban heating seasons after November by steel enterprises, the demand for iron ore in the future is likely to further deteriorate. The iron ore inventory of the steel plant is relatively high, and the willingness to further replenish the inventory is not strong. In terms of supply, the fourth quarter is generally the peak period for the shipment of imported ores. Although the production of domestic mines has been reduced due to environmental protection, the quantity of * * * is relatively limited. In general, the short-term iron ore market may lack upward momentum.Disadvantages: low output, high production cost and high price. Extrusion copper tube process is a stable and excellent copper tube production method at home and abroad at present. Only the copper tubes produced by this process are more suitable for the field of heating and ventilation, when using filler metal, the length of filler metal is allowed to be equal to the diameter of the pipe, which is enough to fill the weld crater. One of the five major application fields of red coppr plate T, red copper bar and red copper tube: copper is the most widely used and used in the electrical and electronic industries, accounting for more than half of the total consumption. Used for various cables and wires, motors and transformers, switches and printed circuit boards; In the manufacture of machinery and transport vehicles, it is used to manufacture industrial valves and accessories, instruments, sliding bearings molds, heat exchangers, pumps etc.

The blowpipe shall be perpendicular to the lead pipe during welding, and the flame shall be moved continuously to prevent local overheating and the flux from carbonizing before filler metal is added.Quality improvement,Save materials and total cost, and can save maintenance.It mainly refers to strengthening the research on copper pipe corrosion and formulating a complete and scientific copper pipe use plan.Red copper plate has ductility. Pure copper, which is as big as a drop of water, can be pulled up to two kilometers of thin wire or rolled into a transparent foil larger than a bed. The most valuable property of red copper row is that it has a very good conductive , second onlyver in common metals. But copper is much cheaper than silver, so it has become the & quot; protagonist& quot; of the electrical industry.Ban La sadaFinland,Ban La sadaFinland6061 aluminum tube,The market opened today. Although the performance of Zitong Pai futures was modest, the overall market has stopped. The market mentality has not changed much sincekend. The price is stable, but some specifications are subject to negotiation, and the negotiation range is about - yuan. The overall rhythm of the market is stable and cold. In the middle of winter, the overall market in Northeast China has entered the traditional off-season, and the overall market has ended with little improvement. All companies are selling goods. The inventory level in Shenyang is very low due to the inventory clearing, and all construction sites have been closed. In addition to the transportation pressure brought by the low temperature, the market was bleak.The conductive production of copper tube is the latest method for this method. It is the production of nanocrystalline copper materials with conductivity. Because this raw material is very special, it is a copper material produced by using nanotechnology, and copper ions can be separated by conductivity, so that copper tubes can be produced with the separated copper ions. This method is very complex, requires high technology and new equipment, so only advanced foreign countries can use this production method.The copper tube shall be heated and welded first, and then the joint shall be heated until the heated part turns dark red. At this time, when the filler metal contacts the tube, the filler metal shall melt.