and solid wood floors are developing towards high wear resistance. Unless you like the coating of this surface.The first is cleaning to remove oil stains or dust;The second is leveling. The convex part shall be shoveled and polished. The concave part can be made into paste with glue and cement at the weight ratio of :
The surface coating of piano paint is actually the paint used on the surface of solid wood floor for laminate floor. It is only bright paint. The wear resistance of this coating is far from that of aluminum oxide surface. Its wear resistance is low, leveled with a spatula, and then leveled with sandpaper after drying.After the ground is flat, clean and dry, it can be glued and paved.Gluing is the last process before paving, and the tool shall be a toothed rubber scraper.During gluing, glue shall be applied on the ground according to the size of the floor paint cloth, and one piece shall be paved in this order.A width of cm shall be reserved at the joint of the floor paint cloth. No glue shall be applied first, so that the joint can be treated finally.When the glue coated on the ground feels sticky by hand, it can be paved. When pasting, pay attention to aligning the sidelines, and use a long handle floor brush to blow out and compact.The joints are generally spliced by overlapping cutting, and the overlapping width is about cm.Align the long steel ruler with the center of the overlap, cut with a cutter along the ruler, then remove the cut edge strips (note that there should be two edge strips,TrondheimFloor seepage, dont forget to take out the lower one), apply an appropriate amount of glue to the joint with a paint brush, and then close and compact the joint with a pressing roller.The residual glue extruded at the joint shall be wiped clean to avoid affecting the appearance.Then apply a thin layer of joint liquid along the joint.Finally, check whether there are bubbles and whether they are flat.If there are bubbles, use a syringe to insert and suck out the air, and then compact it.Finally, use washing powder to remove the residual glue marks on the lacquer cloth. If they cannot be removed,TrondheimWaterproof board, they can be wiped with alcohol.In this way, the whole process will be completed.Due to the improvement of the living standards of Chinese residents, the grade of interior decoration is also rising, and the decoration materials are increasingly developing towards the fixed decoration direction of elegance, high profile, long service life and good effect.As for the ground, the service life of paint, carpet or ordinary floor leather and floor brick is not as long as that of ground lacquer cloth.Trondheim,Laminate flooring does not need waxing and painting, let alone sanding and polishing.The reinforced composite floor itself is relatively smooth and bright, without waxing, and only needs regular maintenance.In short, floor leather is a layer of synthetic plastic decorative products. In addition to many advantages such as wear resistance, pollution resistance, moisture resistance, small water absorption, simple construction, convenient maintenance and low price, it also adds the advantages of comfortable foot feeling, narrowing the gap between wood floor and wood floor. No wonder floor leather will be so popular.If you are also worried about the shortcomings of wood flooring, you might as well consider floor leather materials.Plastic floor leather has the advantages of light weight elasticity, good mechanical strength, good foot feeling strength foot feeling, wear resistance, pollution resistance, corrosion resistance, sound insulation, moisture resistance, small water absorption, good insulation, self extinguishing, easy cleaning, simple construction, convenient maintenance and low price. In a large number of civil buildings and public places, factories with high requirements for cleanlinessIt is widely used in the laboratory.Plastic floor leather belongs to soft floor. It is a floor roll produced by coating or calendering on sheet continuous substrate with polyvinyl chloride resin as the main raw material and appropriate additives.The length of each roll of plastic floor leather is m ~ m, the width is mm ~ mm, and the total thickness is mm (household) ~ mm (public building).Prosteyov,The laminate floor is composed of wear-resistant layer, decorative layer, base material and balance layer.The wear-resistant layer, decorative layer and balance layer are manually printed, and the base material is made of fast-growing forest materials. The cost is lower than that of solid wood flooring. At the same time it can be produced on a large scale, and the relative cost performance is high.Due to the different base materials, the price difference is obvious, and there is more room for customers to choose, which is suitable for people at all levels.Well known brands not only have the test report produced by Chinas quality inspection authority;The marks on the packing box of the product are complete.Registered trademark, manufacturer, business unit, model, address, telephone number,TrondheimHow much is the non slip floor leather per square meter, etc.Here to remind you dont be greedy for cheap to buy three non laminate flooring, so as not to be deceived.First, the price is cheap, several times cheaper than wood flooring, but there are more laminate flooring prices in the market to compete with them;Second, it is easy to clean. Because it is waterproof and water-resistant, it can be scrubbed with water;Third, people can buy according to their preferences and replace them once in two or three years, rather than the trouble of replacing wooden floors;Fourth, it has the advantages of simple installation, convenient use, time-saving, labor-saving and labor-saving.Disadvantages of floor leather
However, SPC floor and plastic are not the same thing at all. SPC floor does not need glue in the production process, does not contain toxic substances such as formaldehyde and benzene, and does not have radiation. It is a green environmental protection decoration material and will not cause harm to human body.Multilayered Wood FlooringThe first kind: pungent taste. If the floor tastes like this it means that it contains a lot of formaldehyde. You need to be careful when choosing. Youd better not buy it;Quality recommendation,For laminate flooring, the main standard of floor environmental protection is formaldehyde emission.In terms of the limitation of formaldehyde emission standards, the environmental protection of the flooring industry has experienced three technological revolutions: E, E and FCF.At an earlier stage, the formaldehyde emission standard of wood-based panel is E level (formaldehyde emission ≤ mg / g), and its formaldehyde emission limit is very loose. Even for products meeting this standard, the formaldehyde content may exceed more than three times that of E level wood-based panel, seriously endangering human health, so it must not be used for home decoration.Therefore, there was the first environmental protection revolution. In this environmental protection revolution, the flooring industry implemented the E level environmental protection standard, that is, the formaldehyde emission is ≤ ‡ / L. although it basically does not pose a threat to the human body, there are still a lot of free formaldehyde left in the floor.The flooring industry has started the second environmental protection revolution and launched E environmental protection standard, which has reduced the formaldehyde emission of the floor to . ‡ / L.The best way to identify whether the floor is environmentally friendly is to pry the floor from the lock with a screwdriver and hammer, so that the floor substrate is exposed in a large area, and then smell it with your nose. A good floor should have a wood smell, but a bad one has a strong pungent smell!durabilityHowever SPC floor and plastic are not the same thing at all. SPC floor does not need glue in the production process, does not contain toxic substances such as formaldehyde and benzene, and does not have radiation. It is a green environmental protection decoration material and will not cause harm to human body.
The surface texture of solid wood floor is clear and natural, there will be some hidden dangers if the crack passes through the texture.Latest quotation, Solid wood flooring. Look at manpower.Enterprises that are really responsible for floor agents have special promotion specialists.These people are experienced, well-trained, resident in the regional market and help the agent hand in hand.If the agency is rare even in the enterprise, where can we start with the support he promised?Some people say this method is unscientific and laminate flooring cant soak in water, but I have done some experiments and come to another conclusion.Trondheim,The current woodworking is basically done by woodworkers. The 'general woodworking' method is adopted, and the shrinkage joint size is not calculated according to the thermal expansion and cold contraction parameters provided by SPC flooring factory.If the room is slightly larger, but the reserved gap is too small, especially when the temperature difference between winter and summer is too large, it is very easy to have no gap to expand, resulting in arching and warping. Keep the floor dry and clean. If there is dirt on the floor surface