There is a difference between submersible slurry pump and sewage pump. Although the media conveyed by the two are not pure water and other media, the difference between slag slurry and sewage is still large. Let&#;s take a look at the difference between the two.　　Different installation requirements: the vertical slurry pump needs to be fixed,GoitapaHorizontal non clogging sewage pump, while the submersible slurry pump does not need to be fixed. It can directly invade into the liquid for operation.Goitapa,　　 If the three-phase current of the submersible sewage pump is large and stable, the submersible pump cannot be started. The reason can only be understood from the submersible pump. Submersible pump bearings may be damaged and the pump may be blocked. The impeller is full of groceries. Submersible pumps shall not be used for sundries, such as those wrapped around the pump shaft　　To repair the equipment. Submersible slurry pump is a machine used to transport liquid. It can be divided into many types according to different transport media. Then, when transporting some media with special properties,GoitapaSingle stage slurry pump, the equipment will be treated with corrosion-resistant and wear-resistant process. Only in this way can the equipment be improvedBurewala,　　Superior, complete protection s, reasonable structure, convenient installation and high cost performance. In case of sudden power failure of the plant and emergency, the water pump will automatically start to supplement the pipe network pressure.　　Rate.　　 In addition, the noise method directly detects the noise of the equipment in the detection process, but this measurement will also be affected by the surrounding noise, so in fact, this measurement is not very accurate.

　　 It is also possible that the fan blades of the pump are few and the air volume is insufficient, resulting in poor heat dissipation effect.　　 Easy installation and maintenance. Small submersible sewage pumps can be installed freely. Large submersible sewage pumps are generally equipped with automatic coupling devices for automatic installation, in fact, we choose to use larger flow. Let&#;s take a look at the method of selecting pumps.Excellent service,　　The utility and durability of the utility model, so the polymer composite materials are generally used in production.　　Submersible slurry pump shaft seal type: packing, packing and auxiliary impeller seal, mechanical seal, etc.　　 First of all,GoitapaCentrifugal slurry pump, we need to choose equipment with formal certificates when making choices. We must avoid buying some obsolete or inferior products. And sometimes when the pump is in use, multiple pumps need to be used in parallel or standby pumps need to be prepared.

　　 confirm whether the pressure capacity of the pipeline meets the requirements, and conduct hydrostatic test if necessary.wholesaler,　　 Before starting the submersible slurry pump, the rotor of the rotating pump shall be smooth and even, and water shall be injected into the pump to ensure that the pump is full of water without air.　　Note: Motors for special environment can be customized according to the contract.　　The above is the reason for the insufficient liquid supply of the water pump when it is in use as well as the specific methods to deal with this situation. We should pay attention to the regular inspection of the equipment during normal use to ensure that it is in useGoitapa,　　It is not correct that it has no effect on us.　　Function of shaft seal of submersible slurry pump: the main of shaft seal is to prevent high-pressure liquid from leaking out of the pump and prevent air from entering the pump.　　 strip the outer layer of the cable to expose the copper wire for to mm, gradually thin the rubber near the wire core grind it to the oxide layer on the wire core, wipe the wire core with alcohol (or hydrochloric acid), wrap the insulation layer and sheath layer, and dry it naturally.