Causes: there is air or gas accumulation in the water inlet pipe of the pump, or the bottom valve is not closed tightly, the water supply is not satisfied, and the gate valve or flap valve is not closed tightly.　　Slurry pump Inappropriate model is selected when selecting the pump. In actual use, when the load conditions do not match the model of the slurry pump, for example, the pump lift used is too high or too low, which will lead to overload,Balao Single suction slurry pump, so we are selecting the pumpBalao ,　　 whether there is oil　　Therefore, the correct selection of shaft seal can ensure the safe and stable operation of slurry pump.Kericho　　Yes, industrial pumps have also increased in recent years.　　For example,Balao Drilling fluid slurry pump, it has a great impact on the impeller of the equipment itself. So how to detect whether the equipment has cavitation during use?　　The application of pumps involves all aspects of work and production, and the types of pumps are also diverse. Some of the same pump have several names, and some of the names are very similar, which makes it difficult to distinguish. Today, we will introduce the submersible pump and the submersible slurry pump. Is there any difference between the two

　　Second, the power used is not matched, so the motor temperature will be too high after long-term overload operation; In addition, frequent startup during use will also lead to fever, so I　　(d) The average maximum relative humidity in the wettest month is %. At the same time, the monthly average minimum temperature is not higher than ℃　　The submersible slurry pump and equipment can also choose to add some water inlet detection devices according to the actual use needs. The overheat monitoring devices are often used in a large amount in time, and the pump and motor of the equipment used in time are the same shaft, soquality,　　 important parts shall be marked in advance to avoid errors during resetting. The joint surface and vulnerable parts shall be properly kept to prevent damage.　　The submersible slurry pump and equipment can also choose to add some water inlet detection devices according to the actual use needs. The overheat monitoring devices are often used in a large amount in time, and the pump and motor of the equipment used in time are the same shaft, so　　The hardened mud layer collapses after softening,Balao Screw deep well pump, avoiding the phenomenon of burying the pump during use.

　　So it has a process of water diversion and exhaust. There are usually two ways to inject water into equipment. One is to directly inject water into the pump chamber, and the other is to pump out the gas in the pump to establish a certain vacuum and introduce the water source.Quality documents,　　Strong strength and other advantages. It is widely used as a sealing device for various pumps. Place a water seal ring at the bottom of the packing box, and then place the filler.　　The submersible sewage pump operates under water. Compared with other motors, the working environment is poor. Regular inspection and maintenance are essential to ensure the 'health and longevity' of submersible sewage pumps!　　Is called cavitation phenomenon.Balao ,　　 If the head of the submersible slurry pump is too low or the head is higher than the practical condition, the flow will be large and the current will rise. At this time, accurate and reasonable selection is very important. In order to select the pump reasonably and correctly, the following aspects need to be considered: Selection of shaft seal form: shaft seal of submersible slurry pump　　After meters the sealing of the equipment can not bear the water pressure at this depth.