Setting requirements: The landing door should be standardized and tooled.Small safe operation distance: Circuit voltage (kV) of external power lines<~~~ Small safe operation distance (m) Setting requirements: A small safe distance should be maintained between the outer edge of the construction electric elevator and the edge of the external overhead power line.Zawelch,The safety overtravel of limit switches and upper limit switches should comply with regulatory requirements.Work is essential, and the main protective accessories include safety belts,ZawelchElectric mobile hydraulic elevator, guardrails, protective covers, platforms and stairs, etc.Adjadabia,Emergency manual valve: In case of power failure, it can cause the car to descend to the nearest floor position and open the doorDrivers of construction electric elevators should hold special construction operations and are not allowed to operate without a certificate.Safety performance: Electric elevators not only have the safety device of traditional traction elevators, but also have an overflow valve to prevent excessive system pressure during upward movement

The landing door should meet the requirements of the specifications and achieve standardization.The counterweight steel wire rope should be equipped with an anti loosening device that is sensitive and reliable.Chain type electric lifting mechanism: With a good guiding mechanism, it can ensure that the equipment does not tilt during operation. Gear and rack electric lifting mechanism: precise transmission and high cost.Quality inspection report,The angle between the wall bracket and the horizontal plane should comply with the requirements of the user manual.Civil engineering advantages: The pit depth of the guide rail type lifting platform is generally around -mm, and the top layer is not affected. It can be customized according to the location and environment.Speed limit wire rope switch. When the speed limit wire rope trips or breaks. Make the electric elevator unable to start.

Secondly, for the replacement of hydraulic oil on the lifting platform, it is recommended to replace it every three months. If the frequency of use is not high, it can be replaced once a year. The hydraulic oil must be clean, and after changing the hydraulic oil, it must be automatically lifted and lowered to times to ensure that the air in the oil cylinder is completely discharged,ZawelchSmall car electric elevator, and ensure that the lifting platform can be lifted to the rated lifting height.Product survey,There is no need to set up a computer room above the shaft like an elevator, and the top floor height can be installed at least . meters.Platform.Operating cost advantage and low failure rate: Due to the use of advanced hydraulic systems and good methods,ZawelchElectric belt elevator, the operating failure rate can be reduced to a low level.Zawelch,It is reported that a fixed electric elevator has good lifting stability and can only be used for fixed operations, making high-altitude operations easierThe net height of the landing door opening should not be less than m, the size of any through-hole and opening related to the distance between any door and adjacent moving parts except for the gap between the lower part of the door that should not exceed mm, as well as the gap around the door or between parts, should comply with the provisions of Table of 'Mechanical Safety - Safety Distance to Prevent Upper and Lower Limbs from Touching Dangerous Areas' GB-.To meet the needs of stage craftsmanship and layout; Product; In the music and dance theater stage arranged in a zigzag pattern, auxiliary lifting platforms are often arranged in front, back left, and right of the main stage lifting platform. The side and rear auxiliary lifting platforms are used for the smooth opening of the side platform and rear vehicle turntable, while the front auxiliary lifting platform is used to place the rear vehicle turntable near the platform entrance. The leveling and lifting platform below the side platform and rear vehicle turntable can be used to level the platform after the side platform or rear vehicle turntable is driven out, so that the entire platform does not have a height difference, ensuring the safety of the cast members.