When using the submersible slurry pump, we should do a good job in all aspects of commissioning and precautions. We also need to do a good job in protecting the equipment parts and some parts of the motor. Only in this way can we avoid the impact of water and other impurities entering the motor　　 confirm whether the pressure capacity of the pipeline meets the requirements, and conduct hydrostatic test if necessary.Kobe,　　Pipeline, plus it can be installed in any position of the water pipeline, so it is named pipeline pump.　　Then it can enter into the volute pump housing. Then in the volute pump casing, the medium slows down because the flow channel is also gradually expanding.Puente Alto , the correct application is very important. Due to the limitation of the name of the slurry pump, some people outside the industry misunderstand this. In fact, the impurity pump, etc. are all in the application scope of the slurry pump　　 If the hot water within ℃ is recommended desilting pump, the hot water pump must be used, and the external tap water shall be connected for cooling during operation,KobeSelf priming slurry pump wholesale, otherwise the motor will not be burned due to too high medium temperature.

　　The fruit is also bad; When the axial flow pump is used, its water output is relatively large,KobeSubmersible pump can pump sewage, but the head is not too high, so the effect of using the submersible slurry pump in many plain areas is also relatively good; The water output and head of the mixed flow pump are actually derived from one　　 total depth of well or pool M　　Then it can enter into the volute pump housing. Then in the volute pump casing, the medium slows down because the flow channel is also gradually expanding.Welcome calls ,　　Discount. In order to meet the needs of industrial production and make the submersible pump to achieve the ideal use effect, the following aspects need to be considered: Selection of shaft seal form: shaft seal of submersible slurry pump　　A large amount of lubricating oil is stored.　　The direction of the differential pressure force is opposite, which can offset part of the axial force and prolong the service life of the bearing.

　　 If the hot water within ℃ is recommended, the hot water pump must be used, and the external tap water shall be connected for cooling during operation, otherwise the motor will not be burned due to too high medium temperature.new product,　　Do not exceed the rated current.　　The treatment method is as follows: try to ensure the stability of the water pump during installation, and the water pump should not be installed too high.　　Be sure to choose a pump that is more suitable for use.Kobe,　　First,KobeLong shaft submerged slurry pump, the reason for the motor body: the wrong connection will make the temperature rise rapidly when the equipment is used; In addition, there may be some phase to phase short circuits between stator windings so when the situation is relatively minor, the motor is only in local places　　 When adding lubricating oil to the pump at ordinary times, the metering must be controlled, and the excess lubricating oil in the pump must be discharged and replaced regularly.　　 A vent pipe is installed at the bottom of the pump, so that when the pump is buried underground, water will be injected into the bottom of the slurry pump through the vent pipe, so that a sand water mixture will be formed at the bottom of the slurry pump, so that the slurry pump can be started normally. The advantage of this approach is that even if