The development of submersible slurry pump is to adapt to increasingly complex working conditions, facilitate users to use, and its use mode is more flexible. And it fills a part of the gap in the application of slurry pump. When the submergence depth is deep and there is no better slurry outlet, that is, in the traditional slurry pump　　 Then tighten the compression nut on the packing gland evenly to make the liquid leak out in drops,VanazolSubmersible non clogging slurry pump, and pay attention to the temperature rise outside the packing chamber.Vanazol,　　In terms of performance parameters, optional flow range: - (m/h), lift range: - (m),VanazolFire deep well pump, power range: .- (kw), caliber range: - (mm).　　 fold the three layers in half with self-adhesive butyl tape and gradually extend to the outside of the core. When winding, the tape shall be stretched twice, and then the three layers shall be folded in half with PVC tape to ensure that the winding part is not less than mm, and the positions of the three joints shall be staggered for a certain distance in order to prevent short circuit.Ma-kung,　　If the water leakage is serious, the broken pipe shall be dismantled and replaced. Lower the lift and press the nozzle of the water pump into the water for .m.　　What is the solution to this situation?　　Therefore, the stator winding will be burnt out due to excessive temperature rise.

　　In fact, the pumps I am going to talk about here have a wide range of uses. Pumps are required for both civil and military purposes, especially in the mining, chemical, metallurgical and other industrial sectors. It is a widely used general mechanical equipment. Most pumps are corroded or severely corroded　　Easy installation and disassembly.　　Although the shaft seal occupies a small position in the pump, the normal operation of the pump is closely related to the shaft seal.Let's see,　　Carbon, building materials, chemical industry and other industrial industries are mainly used to transport abrasive pastes containing solid particles.　　If there are sundries blocked, the pump will not be filled with water. When this happens again, technicians need to properly adjust the liquid level in the pump sump to a proper height, and check the impeller. In case of damage or aging, it needs to be replaced in time　　 drainage and water injection with vacuum equipment: the self exhaust of centrifugal pump is the same as the negative pressure exhaust of vacuum pump, so the water ring vacuum pump is used for exhaust to achieve the of water inlet.

　　The disc friction loss of the slurry pump impeller will decrease with the decrease of the impeller diameter, so that the pump efficiency of most low specific speed pumps will improve slightly after the impeller is cut. After cutting, keep the blades overlapped to a certain extent, and the degree of blade overlap will decrease with the addition of specific speedaverage method,　　The water pump can be used to transport and pressurize clean water without impurities, residence, villa water supply, factory water supply, water supply system, drinking water system and water treatment. In short, there are many uses.　　 Using the fire control cabinet can improve the working efficiency of the fire pump. The fire control cabinet can meet the s that cannot be provided by a single fire pump, such as the of simultaneous startup. In some dangerous situations, a single fire pump can not meet the needs, and multiple fire pumps are required to work at the same time　　After that, before starting again, check whether the impeller rolling is normal and whether the bearing assembly compression bolts are tightened and then start the pump.Vanazol, the submersible slurry pump can also be used as a mobile slurry pump, such as sand pumping and prospecting on board; What are the advantages of the submersible slurry pump? The advantage of the submersible slurry pump is that it is convenient and flexible, easy to operate and submerged　　Rate.　　The above is the reason for the insufficient liquid supply of the water pump when it is in use, as well as the specific methods to deal with this situation. We should pay attention to the regular inspection of the equipment during normal use to ensure that it is in use