The submersible slurry pump is a kind of submersible pump which is connected with the motor and works underwater at the same time. In addition, compared with horizontal slurry pump and vertical slurry pump, submersible slurry pump has the great advantage of flexibility and convenience, and is more suitable for various working conditions. The important technical points of submersible slurry pump are its motor and　　 Before starting the submersible slurry pump, the rotor of the rotating pump shall be smooth and even,YogyakartaISG single stage vertical pipeline pump, the outlet sluice valve shall be closed, and water shall be injected into the pump to ensure that the pump is full of water without air.Yogyakarta,　　The rotating parts of the water pump are loose and damaged.　　Carbon, building materials, chemical industry and other industrial industries are mainly used to transport abrasive pastes containing solid particles.Sahline,　　 the water pipe shall be provided with a gate valve to regulate the pump working point. The valve shall be installed as close to the pump outlet as possible. The pump unit greater than meters shall be provided with a check valve at the pump outlet. In case of sudden shutdown,YogyakartaRubber lining submerged slurry pump, it is necessary to prevent damage to flow passage components caused by water hammer.　　 If there is no corresponding water leakage sensor, it is necessary to regularly maintain the submersible slurry pump and replace the seals.　　Do a good job of fixing to avoid the motor falling into the water and directly scrapping.

　　The above is the reason for the insufficient liquid supply of the water pump when it is in use, as well as the specific methods to deal with this situation. We should pay attention to the regular inspection of the equipment during normal use to ensure that it is in use　　 Assembly of electric pump: assembly sequence of motor: stator assembly → lower guide bearing assembly → rotor assembly → thrust disc → left nut → thrust bearing assembly → base assembly → upper guide bearing seat assembly → skeleton oil seal → connecting seat. Adjust the studs so that the motor shaft extension meets the specified　　 repair and level the welding part of the submersible slurry pump with a file, clean the part to be bound with alcohol again and wipe it dry.supply,　　Do not exceed the rated current.　　When the equipment is in use, the water delivered in the pump receives the friction with the surface of the pump impeller, so the pump needs to consume more energy to reduce the friction and resistance caused by the surface when it is rotating. Water will slowly overcome it as it flows　　When the submersible slurry pump is used at ordinary times, cavitation usually occurs, which has a great impact on the impeller of the equipment itself. So how to detect whether there is cavitation when using the equipment at ordinary times?

　　If the water leakage is serious, the broken pipe shall be dismantled and replaced. Lower the lift and press the nozzle of the water pump into the water for .m.Which one is better　　Yes, such mechanical faults will cause the stator winding of the pump to be burnt out.　　Microcomputer controller LW light: cause: the light is on and the machine stops the water level is low, the water level returns to normal,YogyakartaZD slurry pump, and the machine starts automatically.　　The submersible slurry pump shall be shut down for inspection in time in case of machine problems during operation, and regular maintenance shall be done. The equipment will not be used after burning out, which will cause certain economic losses to us.Yogyakarta,　　Slurry pump Inappropriate model is selected when selecting the pump. In actual use, when the load conditions do not match the model of the slurry pump, for example, which will lead to overload, such mechanical faults will cause the stator winding of the pump to be burnt out.　　 Then replace the pulley and pump cover plate and tighten the fixing nuts.