the temperature of the motor is very high

　　During normal operation, some even as high as ℃. In this case, it is easy to burn the motor and replace it with a new one. In fact, one motor burns out at this time. Don&#;t worry about replacing it. You must find out the cause of the motor&#;s heating, the maximum design depth of our company&#;s underwater slurry pump can reach m and of course it can be more than. For example submersible slurry pump appears in response to market demand. It is especially suitable for the depth at which the vertical slurry pump cannot operate. The underwater part of the vertical slurry pump is generally not more than m,TongjipalaCorrosive pipeline pump,TongjipalaVortex pump and pipeline pump, but such underwater depth is not the best operating depth of this kind of pump, so it will lead to the unreliability of the operation of the vertical slurry pump from time to time.Tongjipala,　　Whether the pipe is blocked or the valve is not opened; D. whether the water pump is reversed.　　First, the reason for the motor body: the wrong connection will make the temperature rise rapidly when the equipment is used; In addition, there may be some phase to phase short circuits between stator windings, so when the situation is relatively minor, the motor is only in local placesFighter,　　In this way, a smooth surface can be formed on the surface.　　Balance of.　　What stands out is the sealing of the container. The seal is easy to install and maintain, stable and reliable, but the price is quite expensive.

　　The water pump can be used to transport and pressurize clean water without impurities, such as apartment,TongjipalaSelf priming slurry pump wholesale, residence, villa water supply, factory water supply, water supply system, drinking water system and water treatment. In short, there are many uses.　　 Pipeline pump: the pipeline pump is a centrifugal pump with the same inlet and outlet in the same straight line and the same caliber. It can be installed in series at any position of the pipeline like a section of pipeline, so it is called pipeline pump. It is defined and named according to the special appearance of the pump. If it is named according to the principle, the pipeline pump is a special structure　　All kinds of newly designed mechanical seals of submersible slurry pumps contribute greatly to the growth of market share.Latest quotation, resulting in poor heat dissipation effect.　　Submersible slurry pump In addition, it must be used continuously during transportation. If there is an interval in the middle, it must be avoided that the interval is relatively long, so as to avoid the solidification of slurry in the pump when the operation is stopped.　　 selection of pump head: generally, the pump head shall be determined by enlarging the margin of % - %.

　　About %), and motor power p=i × U indicates that high power and current will increase.market price,　　 Selection of pipeline diameter: the selection of pipeline shall consider the one-time purchase cost, long-term operation cost and operation reliability.　　 When the electric pump is not in use, take it out of the water and do not immerse it in the water for a long time, so as to reduce the chance of the motor stator winding getting damp and increase the service life of the electric pump. When the temperature is low, the pump needs to be lifted out to prevent freezing.　　So it has a process of water diversion and exhaust. There are usually two ways to inject water into equipment. One is to directly inject water into the pump chamber, and the other is to pump out the gas in the pump to establish a certain vacuum and introduce the water source.Tongjipala,　　If the oil seal ring of the shaft is seriously worn, replace it with a new one.　　Water or air leakage in the pipeline. The nut may not be tightened during installation. If the leakage is not serious, tighten the nut with a wrench. as　　 Next, the water seal, lock ring and other parts need to be installed.