The angle between the wall bracket and the horizontal plane should comply with the requirements of the user manual.Setting requirements: A limit switch should be set at both the upper and lower ends of the stroke, which should be able to cut off the power supply before the suspension cage and other mechanical stop devices (such as buffers),HelenFixed electric elevator, so that the suspension cage can stopThe spacing between wall brackets and the height of guide rails above the high attachment point should comply with the requirements of the user manual.Which one is better,Setting requirements: The spacing of wall brackets along the vertical direction should comply with the provisions of the user manual.The distance between the electric hoist and overhead line in Electrical safety construction shall meet the specification requirements, otherwise protective measures shall be taken.Buffer. In order to increase the energy for the car to hit the top or sink to the bottom. Remove rubber or sponge from the buffer and cabin to increase their impact energy; Rope groove slipping and other accidents caused the car to suddenly fall, resulting in a safety clamp. To prevent breakage of the lifting wire rope. A safety clamp that can simultaneously cut off the power supply and stop the car from falling should be removed from the car. A car without safety tongs is not allowed to ride or carry people. If it is a simple electric elevator, there should be a safety device (such as a safety stop pin) to prevent people from suddenly falling when loading and unloading goods in the car; Electric elevators with three or more floors (including three floors) for passengers or passengers.
There is no need to set up a computer room above the shaft like an elevator, and the top floor height can be installed at least . meters.Sincere service,Speed limiter. To prevent the driving speed from exceeding the normal speed. A speedometer should be installed (not required for floors below or including the second floor), which is an individual mechanism that is integrated with a safety clamp; The entrance and exit of the passenger compartment should be equipped with safety doors. Public places, family dormitories, andThe working principle of the aluminum alloy lifting platform is that hydraulic oil is composed of a vane pump to form a certain pressure, which enters the lower end of the hydraulic cylinder through an oil filter, throttle valve, hydraulic control one-way valve, and balance valveProtective measures should comply with regulatory requirements.Helen,HelenSmall car electric elevator,HelenFreight elevator electric elevator,Safety performance: Electric elevators not only have the safety device of traditional traction elevators, but also have an overflow valve to prevent excessive system pressure during upward movementThe bearing capacity of the building structure at the attachment point of the wall bracket should meet the requirements specified in the user manual for construction electric elevators.Setting requirements: The verticality deviation of the installation of the guide rail frame of the construction electric elevator should comply with the requirements of the user manual and specifications, as specified in the above table.
Do you have Helen24 volt electric elevator here? Helen24 volt electric elevatorWhat is the spot price
When Helen24 volt electric elevator offer discount points for activities, contact me when there are discounts
The manager is nice! Helen24 volt electric elevator is also real.
A good seller, even a novice, a lot of Helen24 volt electric elevator don’t understand. Fortunately, the seller has patient guidance on the other end of the computer, and I have a sense of accomplishm
Helen24 volt electric elevator Very good, I will order yours for the next batch.
It's worthy of praise, really good, Helen24 volt electric elevator I like it very much.