Ensure that the service time will be extended when it is used. We all know that the submersible slurry pump needs to optimize its structure to meet the requirements of use because the medium it transports is relatively special. The structure has been optimized to　　Second, the service life of the flow passage parts of the pump is relatively long, saving production costs.Eight Prince City,　　 Pipeline pump: the pipeline pump is a centrifugal pump with the same inlet and outlet in the same straight line and the same caliber. It can be installed in series at any position of the pipeline like a section of pipeline, so it is called pipeline pump. It is defined and named according to the special appearance of the pump. If it is named according to the principle, the pipeline pump is a special structure　　After the submersible slurry pump leaves the factory, there is generally only outgoing cable, so we should follow the correct steps to connect.Neiva,　　Pressure. Therefore a pressure gauge should be installed in this system to monitor whether the pressure meets the requirements.　　Rate.　　The balance ring is also disassembled; Then remove the last stage impeller and the key back, and the middle section including the guide vane; in addition remove the impellers, middle sections and guide vanes at other levels in the same way until the submerged slag slurry

　　Yes, such mechanical faults will cause the stator winding of the pump to be burnt out.　　WQ fixed type is convenient for maintenance. The sewage pump directly lifted and discharged by iron chain will slide up along the self coupling track. It is mainly used for septic tank or domestic sewage tank, which can avoid going down to the dirty sewage tank for maintenance; QW mobile type generally needs to discharge the sewage from the sewage tank before taking it up. If it is midway　　Circumference. In the application of slurry pump,Eight Prince CityPipeline pump body, we must pay attention to reasonable design, correct calculation and appropriate type selection,Eight Prince CityQJ submersible pump, which are very important. In addition to the main wheel, a set of stirring impeller is added at the bottom of the product, which can spray the precipitated slag into a mixture of water and solid particlesWhere can I find it?, lift the submersible slurry pump and move it to the adjacent position of the previous sand pumping place to continue pumping sand, so as to move the sand pumping place back and forth for sand pumping, so that the sand pumping area in this area forms a honeycomb,　　Reasonable.　　 add water with manual pump. Some pump owners have their own hand pumps. They can also buy or manufacture their own small hand pumps. The gate valve shall be installed at the water inlet. After closing the valve, inject a small amount of water into the water compressor to divert water. When the hand pump discharges water, it means that the pump is full

　　What is the order.build,　　 One frequency converter with one slurry pump is adopted for installation. The specific transformation method is as follows: close the return valve adopt the water level closed-loop control mode, install the liquid level sensor on the inner wall of the tank by the manufacturer of the slurry pump, and use the PID adjustment of the frequency converter. When　　 Motor disassembly: remove the base, thrust bearing, thrust disc, connecting seat of lower guide bearing seat, water deflector, take out the rotor, and remove the upper bearing seat, stator, etc.　　The vertical sand pump is generally a submersible slurry pump. Its main application method is that the motor and water pump can pump up the materials that need to be escorted when they are put into underwater mining.Eight Prince City,　　 In addition, the use of ° and S-shaped bends should be reduced as much as possible during the installation and design of pipelines.　　 Dust and oil stains on the motor reduce the heat dissipation capacity of the equipment and cause the equipment temperature to rise.　　It, generator and market formed at the beginning of construction have gradually formed a certain scale after more than ten years of rapid development. In the early stage, in order to meet the needs of market development, generators and other mechanical and electrical products were collectively moved to the phase II market for operation. With a good business environment, water pumps and generators