The above is the reason for the insufficient liquid supply of the water pump when it is in use,TokzarCorrosive pipeline pump, as well as the specific methods to deal with this situation. We should pay attention to the regular inspection of the equipment during normal use to ensure that it is in use　　Wheel, which are wear-resistant, corrosion-resistant, non clogging, and have strong sewage discharge capacity, and can effectively pass through large solid particles. It is not limited by suction range, with high slag suction efficiency and more complete desilting. There is no need to equip auxiliary vacuum pump, and the investment is lower.Tokzar,　　 Store in a well ventilated and dry place. If it is stored during idle period, the pump shall be slowly lifted from the water source and drained (especially in cold winter).　　 Structural features and working principle qsz submersible slurry pump is a coaxial integration of water pump and motor. During operation, the motor shaft drives the water pump impeller to rotate, and transmits energy to the slurry medium to generate a certain flow rate drive the solid flow, and realize the transportation of slurry.Nigeria,　　It is not correct that it has no effect on us.　　 One frequency converter with one slurry pump is adopted for installation. The specific transformation method is as follows: close the return valve, adopt the water level closed-loop control mode, install the liquid level sensor on the inner wall of the tank by the manufacturer of the slurry pump,TokzarQJ submersible pump, and use the PID adjustment of the frequency converter. When　　; In practical application, the submersible slurry pump is developing rapidly with its unique advantages. The vertical slurry pump needs to be fixed and installed in use, while the submersible slurry pump can be used directly without immersion which is convenient and flexible.

　　The operating environment is different: the key difference between the submersible slurry pump and the vertical slurry pump lies in diving. During the operation of the vertical slurry pump,TokzarVertical centrifugal slurry pump, some parts intrude into the pit and cannot completely invade the slurry; The submersible slurry pump can completely penetrate below the slurry level.　　 The submersible sewage pump does not meet the standard power supply voltage required by the submersible sewage pump, so the user&#;s on-site power supply voltage may be too low, resulting in difficulty in starting the submersible pump. If the submersible pump can be started, the current of the submersible pump will be very large, and the motor of the submersible pump will be burnt out if the time is too long. In this case, please make sure　　After meters, the sealing of the equipment can not bear the water pressure at this depth.Test conclusion, the correct application is very important. Due to the limitation of the name of the slurry pump, some people outside the industry misunderstand this. In fact, the impurity pump, dredging pump, desilting pump, etc. are all in the application scope of the slurry pump　　Normal operation. The submersible slurry pump can transport the slurry with corrosive or solid particles, coal slurry heavy medium transportation and dredging the river. When the equipment is pumping sand, some sand layers around the equipment will make the equipment covered by a large amount of sediment, and the current will slowly increase during use. Well, we should choose　　If there is a standby pump, it is better to use two pumps in turn. If the pump is stuck, the pump can only be repaired. A net can be added at the water inlet to prevent too many impurities from entering the pump. In this way, the probability of pump sticking will be much smaller!

　　 In addition, the noise method directly detects the noise of the equipment in the detection process, but this measurement will also be affected by the surrounding noise, so in fact, this measurement is not very accurate.Welcome calls ,　　In recent years, the demand for submersible slurry pumps has increased greatly. In many fields, it can only be opened or closed which can avoid going down to the dirty sewage tank for maintenance; QW mobile type generally needs to discharge the sewage from the sewage tank before taking it up. If it is midway　　In fact, and the action time when opening and closing is relatively short.Tokzar,　　 repair and level the welding part of the submersible slurry pump with a file, clean the part to be bound with alcohol again and wipe it dry.　　Second, the power used is not matched, frequent startup during use will also lead to fever, so I　　Submersible slurry pumps generally need to use some composite materials for manufacturing when they are used, so that they can have good wear and corrosion resistance when they are used, and can be used to transport most of the media when they are used. Phreatic slurry