It needs to be replaced in case of damage swelling and deformation, insufficient spring pressure, breakage, etc.　　According to the user&#;s requirements, the motor can add a variety of protection devices such as water inflow detection and overheating, so that the product can operate safely for a long time under adverse working conditions.Al Musayyib ,　　Control type Liquid level control: the control cabinet is equipped with a high-performance key float switch to automatically control the start and stop of the water supply and drainage pump according to the high and low changes of the liquid level.　　It is an auxiliary means for some on-site monitoring.Pop,　　The use of water pumps is related to all aspects of our life. With the arrival of the May Day holiday, the water consumption will increase. Therefore, and different pump models have different performance and application fields. Therefore,Al Musayyib Pipeline pump, although the pump has a wide range of applications, if its model is not correctly and reasonably selected, its application effect will be great　　Submersible slurry pump In addition, it must be used continuously during transportation. If there is an interval in the middle,Al Musayyib Corrosive pipeline pump, it must be avoided that the interval is relatively long, so as to avoid the solidification of slurry in the pump when the operation is stopped.

　　The equipment is integrated with the oil cooler, which has good sealing effect. Submersible slurry pump is a kind of solid-liquid mixing medium with the help of centrifugal force　　 Assembly of electric pump: assembly sequence of motor: stator assembly → lower guide bearing assembly → rotor assembly → thrust disc → left nut → thrust bearing assembly → base assembly → upper guide bearing seat assembly → skeleton oil seal → connecting seat. Adjust the studs so that the motor shaft extension meets the specified　　 Moreover, the processes of these two pumps are also different, and the sewage pump can generally be adjusted. Submersible pumps are generally used in some special or other places.Click to view,　　Commodity.　　Do a good job of fixing to avoid the motor falling into the water and directly scrapping.　　It is an auxiliary means for some on-site monitoring.

　　 The fixing method of the impeller is changed from screw thread to key clamp to prevent the impeller from falling off and causing damage!discount,　　Troubleshooting: first increase the water pressure, then inject water into the pump body, and then start the pump. At the same time, check whether the check valve is tight and whether the pipes and joints leak. If air leakage is found, apply lubricating oil or mixed paint on the joint after disassembly, and tighten the screws.　　 allowable maximum outer diameter of downhole part of pump mm　　First,Al Musayyib Pipeline pump body, let&#;s talk about the familiar vertical slurry pumps. Here we refer to ZJL and SP submerged slurry pumps. Strictly speaking, the submersible slurry pump is also a vertical slurry pump, because its axis is basically vertical when it works but it can be completely immersed in water when it runs, so it is a good choiceAl Musayyib ,　　The above is a brief introduction to the effect and form of shaft seal of submersible slurry pump. Users can choose the appropriate shaft seal type according to their actual needs.　　The premise of using this method is that the water gun must have sufficient flow during use, otherwise the effect of the submersible slurry pump may not be obvious.　　 Before starting the submersible slurry pump, the rotor of the rotating pump shall be smooth and even, the outlet sluice valve shall be closed, and water shall be injected into the pump to ensure that the pump is full of water without air.