The mixing impeller and other main flow passage parts are made of high wear-resistant materials, which are wear-resistant, corrosion-resistant, and can effectively pass through large solid particles. It is not limited by suction range, with high slag suction efficiency and more thorough desilting. No auxiliary vacuum pump is required and the investment is lower. nothing　　 The submersible slurry pump usually relies on water cooling to dissipate heat. If the motor leaks out of the water without water cooling,FeldabadSewage pump diving,FeldabadZD slurry pump, the motor temperature will rise, so it is easy to burn out the motor.Feldabad,　　 Check and replace accessories regularly: check cables,FeldabadSelf priming slurry pump wholesale, motor insulation and screws at least once a year. If it is damaged, it should be replaced in time.　　Friction. Because if the surface of the pump is smooth when it is used, the submersible slurry pump and impeller are sprayed with polymer composite materials for useZhuozhou ,　　Work, no noise and vibration, and the site is cleaner.　　Strong strength and other advantages. It is widely used as a sealing device for various pumps. Place a water seal ring at the bottom of the packing box, and then place the filler.　　If the water leakage is serious, the broken pipe shall be dismantled and replaced. Lower the lift and press the nozzle of the water pump into the water for .m.

　　 install the front pump shaft first and then the rear bearing for the slurry pump of the filter press of the cylindrical bearing box.　　In this way, the upper guide housing is installed in turn. After the pump is installed, pull the pull nut, take out the gasket, tighten the pull nut evenly, no noise and vibration, and the site is cleaner.Create brilliance,　　As a submersible slurry pump widely used in many fields, it has the advantages of simple structure, convenient disassembly and maintenance and convenient installation and use. The change of the sealing structure of the pump avoids the direct damage to the bearing after the mechanical seal is damaged, and the service life of the bearing has also been greatly changed.　　The submersible slurry pump is a slurry pump which is connected with the motor and works under the water at the same time. Compared with horizontal slurry pump and vertical slurry pump, the biggest advantage is that it is flexible, convenient and easy to apply to various working conditions. The most important technical point of submersible slurry pump is the tightness between its motor and pump body Stability and reliability of seals.　　 the submersible slag pump is often used to transport pulp containing solid particles, so the wear resistance of the pipeline should also be considered.

　　Water flow into the bearing damages the bearing.Free consultation,　　This phenomenon shows that the failure of the pump is not only a material problem, but also reminds the pump designers and producers that in addition to good working conditions, the pump should also have good corrosion resistance, high reliability and long service life. The pump shall be designed in addition to the conventional design method of fluid mechanics　　 whether pre lubrication water tank is required　　The two have certain commonalities. They are both submersible. As the name suggests, the pump is in an invasive state when running. The submersible slurry pump is a kind of submersible pump but generally speaking, people often say that the submersible pump refers to the clean water pump, such as the submersible pump for domestic water and farmland irrigation and pumpingFeldabad,　　 the water pipe shall be short and the cavitation allowance of the device shall be greater than that of the pump. It is recommended to use the reverse charging installation method when transporting residues with high weight concentration.　　Screw it down, and then remove the bearing inner race, O-ring, shaft sleeve and retaining sleeve in turn.　　It needs to be replaced in case of damage, swelling and deformation, insufficient spring pressure, breakage, etc.