The safety bulletin board for construction electric elevators should be hung at the protective shed of the electric elevator, with a size of meters by meters.Tank oil temperature protection: When the oil temperature in the tank exceeds the standard setting value, the oil temperature protection device sends a signal to suspend the use of the elevator. The elevator can only be started when the oil temperature dropsLiaoning,Savings, rate of increase and decrease. To ensure safe and reliable braking and prevent accidents, a hydraulic control one-way valve, also known as a hydraulic lock,LiaoningSmall car electric elevator, is added to prevent hydraulic pipelines from exploding and self locking safely. Installed overloaded voice control alarmHigh lifting height, using side mounted oil cylinders, stable operation, noise free,LiaoningSimple electric elevator, easy maintenance, and longer service life.Antsohihy, a torque wrench or special tool should be used to accurately tighten the bolts to the specified torque value according to the specified tightening sequence. When installing standard section connecting bolts it is advisable to place the screw at the bottom and the nut at the top.The use of standard section connecting bolts should comply with the user manual and specification requirements.There is no need to set up a computer room above the shaft like an elevator, and the top floor height can be installed at least . meters.

Drainage measures need to be considered around the foundation. (Drain the accumulated water on the foundation).The counterweight steel wire rope should be equipped with an anti loosening device that is sensitive and reliable.The angle between the wall bracket and the horizontal plane should comply with the requirements of the user manual.knowledge,To ensure safe and reliable braking of the lifting platform and prevent accidents, a hydraulic control one-way valve, also known as a hydraulic lock, is added to ensure safe self-locking in the event of an accidental rupture of the hydraulic pipeline. An overload sound control alarm has been installed to distinguish between overload or equipment failure. Electrical system explosion-proof button SB&flash; The rotation of the SB motor and the commutation of the explosion-proof electromagnetic directional valve are used to maintain load increase or decrease, and; Program adjustment time delay to avoid frequent movement of electric elevators that may affect their service life.Installation and dismantling personnel and drivers should hold certificates to work.The landing door should meet the requirements of the specifications and achieve standardization.

Construction electric elevators outside the lightning protection rangeWork courses,Setting requirements: The foundation and foundation of the construction electric elevator should meet the requirements of the user manual. Before installing the construction electric elevator, the foundation should be inspected and accepted according to the requirements of the specifications. Only after passing the inspection can the installation be carried out.The shutdown device (emergency stop switch) should be non automatic reset type.Manual pump: When the system malfunctions, the manual pump can be operated to pump high-pressure oil to raise the car to the nearest floor positionLiaoning,LiaoningMobile electric hydraulic elevator,Implementing multiple shifts of homework should fill in and submit records according to regulations.Low level doors should be equipped with interlocking devices that can verify their closed and locked positions. The action of this interlocking device should be at the entrance of the cage. Simple use should not interfere with the operation of the interlocking device. The attached wall bracket should use matching standard products. When the wall bracket cannot meet the requirements of the construction site it should be designed separately. The design of the wall bracket should meet the requirements of component stiffness, strength, etc., and the production should meet the design requirements.The advantages and disadvantages of several commonly used electric lifting mechanisms are as follows: hydraulic electric lifting mechanisms: using hydraulic technology, smooth lifting and low noise.