we can solve the problem: First

　　Water pump After understanding the cause of insufficient liquid supply, we need to check whether the liquid level of the circulating liquid storage tank needs to add media to it.　　Third,ChongqingCirculating hot water pipeline pump, the whole industrial and mining system operates stably, and the operation of the pump will not affect the work of the whole industrial and mining system.Chongqing,　　Friends who are more concerned about this issue can dispel their concerns.　　If there is a standby pump, it is better to use two pumps in turn. If the pump is stuck, the pump can only be repaired. A net can be added at the water inlet to prevent too many impurities from entering the pump. In this way, the probability of pump sticking will be much smaller!Sao Domingos de Rana　　If the oil seal ring of the shaft is seriously worn, replace it with a new one.　　Sex is different. Although the submersible slurry pump is widely used, the correct application is very important. Due to the limitation of the name of the slurry pump, some people outside the industry misunderstand this. In fact, the impurity pump, dredging pump, desilting pump, etc. are all in the application scope of the slurry pump　　Whether it is the pre installation inspection or the post installation commissioning inspection, the correct operating procedures must be strictly followed. Only the correct operating steps can make the product play an effective role in the use site.

　　 Next, it is necessary to check the water seal. If the water seal is bakelite and the wear is not too serious, you can place abrasive cloth on the glass or dry wood, and then grind the water seal of Boshan submersible slurry pump flat or turn it over for use. However, if the thrust rubber water seal is used, when　　Self priming pumps of different materials are used.　　When the water level reaches,ChongqingCorrosive pipeline pump, the frequency of the frequency converter drops, and the slurry pump operates at a low speed. The higher the water level, the lower the speed; The lower the water level, the higher the speed. At the same time, the water level signal is transmitted to the control cabinet so that the operators can timely understand the liquid level. Through this control, the circulation in the slag slurry pool is basically unchangedWelcome calls , you can start working.　　 selection of flow: single suction pump or double suction pump shall be selected according to the flow; single suction pump or multi suction pump shall be selected according to the lift.　　Some of them are OK. For irrigation and other purposes, in fact, we choose to use larger flow. Let&#;s take a look at the method of selecting pumps.

　　 The fan speed of the water pump is too low, and the air pressure and air volume are relatively small, so the heat cannot be dissipated.How many?,　　It will generate heat, but when it is serious, it will directly burn out the insulation; There may also be some faults in the ventilation system. At this time,ChongqingPipeline pump body, it is necessary to check whether the fan of the submersible slurry pump is damaged or rotating　　Self priming pumps of different materials are used.　　 The submersible slurry pump usually relies on water cooling to dissipate heat. If the motor leaks out of the water without water cooling, the motor temperature will rise, so it is easy to burn out the motor.Chongqing,　　After the submersible slurry pump adds a water gun to the support at the bottom of the submersible slurry pump, the hardened mud layer around the slurry pump will collapse rapidly under the applied water pressure, which will also increase the sand pumping area. This will also increase the sand pumping area, so there will be no buried pump when it is used. However,　　When this type of pump is used at ordinary times, the pump and motor operate in a coaxial whole. When it runs the motor shaft will drive the impeller of the pump to rotate, the rotating force can be brought to the medium